← Back to TS20 Tactile Servo (TS20-49C / TS20-99C)
USB-to-RS485 Communication Adapter
Official USB Type-C to RS485 interface board for TS20 Tactile Servo debugging, telemetry & daisy-chain control.
$19 .00
Ships by January 11, 2027
USB-RS485 Adapter x 1
Interface & Pinout DiagramHOST INTERFACEUSB Type-C Plug & Play
Driver-free operation on Windows, Linux, and macOS (data cable required).
DAISY-CHAIN BUSUp to 16 Servos (1M–7.5M bps)
Proprietary half-duplex RS485 differential bus with CRC16 frame verification.
DUAL CONNECTORSPH2.0-4P + 5.08mm Terminal
Direct plug-in socket or screw terminal block (Red / Black / Yellow / Green).
POWER & PROTECTIONDC 18–32V (24V Recommended)
Built-in ESD protection and 120Ω termination resistor solder pads.
USB-RS485 Adapter
1
TS20 Companion Development Accessory · Recommended Purchase
This product is a dedicated companion accessory for TS20 Tactile Servos (TS20-49C / TS20-99C), engineered for development, parameter debugging, and real-time bus control. Recommended purchase when ordering tactile servos.
Technical Specifications & Pinout
- Power Input Voltage
- DC 18V – 32V (24V Recommended)
- Power Terminal Polarity
- Top: Negative (–) · Bottom: Positive (+)
- Host Interface
- USB Type-C (Data & Logic Power Only)
- Bus Communication
- Half-Duplex RS485 Differential Bus (Proprietary Protocol, Non-Modbus)
- Supported Baud Rates
- 1M–7.5M bps
- Daisy-Chain Capacity
- Up to 16 Servos per Bus (Address 0–15, CRC16 Verified)
- Servo Connectors
- PH2.0-4P Socket + 5.08mm 4P Terminal (Use Either, Not Both)
- OS Compatibility
- Windows, Linux, macOS (Driver-Free Plug & Play)
- On-Board Protection
- ESD Protection + 120Ω Termination Resistor Solder Pads
- Net Weight
- 18 g
⚠️ Wiring & Power-On Safety Instructions:
- No Reverse-Polarity Protection: Connect DC 18–32V strictly with Negative (–) at Top and Positive (+) at Bottom. Reversing polarity will permanently damage the board.
- Power-On Sequence: 1. Complete all wiring → 2. Connect DC 18–32V power supply → 3. Connect USB Type-C data cable to PC.
- No Hot-Plugging: Do not connect or disconnect servo cables while powered. Match wire colors strictly (Red: VCC, Black: GND, Yellow: 485_N, Green: 485_P).
Pre-Order & Dispatch: Full-payment pre-order. Estimated dispatch: Ships by January 11, 2027. Dispatch follows the pre-order launch schedule, not the date you place your order. You may cancel anytime prior to shipment for a 100% full refund.
International Shipping & Customs (DDU): Shipped globally via FedEx / DHL under DDU (Delivered Duty Unpaid) terms. Destination customs duties and taxes must be paid by the recipient upon arrival — please check your local product category and applicable tariff rates in advance.